Conveyor Belt Tension And Alignment-Tail End - USC SS16 Operator's Manual

CONVEYING BELT TENSION AND ALIGNMENT - TAIL END
To maintain the belt, follow this procedure:
Place all controls in neutral or off, stop motor and disable power
NOTICE
source before working on belt.
1. Use the take-up bolt located at the tail to set the tension of the belting.
2. If the belt needs to be tightened to prevent slippage, use the take-up adjustments
on the tail end only.
3. The belt is tightened by turning both take-up adjustments an equal number of
turns.
4. Use the drive roller to check the alignment. The belt should be centered.
5. Turn the belt 1/2 revolution when the belt is new and check the drive and tail roller.
If out of alignment, the belt will move to the loose side. Loosen the jam nut and use
the bearing position bolts to set the position. Tighten jam nut.
6. Run and check again. Check frequently during the first few minutes of operation
and then several times during the first 10 hours. The belt normally seats itself
during the first 10 hours of operation and can be checked weekly after that.
7. The belt is properly aligned when the belt runs in the center of the head and tail
rollers.
Use this bolt to
tighten and
align the belt
USC CONVEYORS
This nut will free and
secure adjustment bolt.
Page 71