Section B; Installation - USC SS16 Operator's Manual

NOTICE
UNDERCARRIAGE ASSEMBLY 20 - 35 FT CONVEYORS
The following instructions should be used to assemble your USC conveyor
undercarriage. Hand tighten all fasteners until undercarriage is completely assembled.
The undercarriage for each length of conveyor (20 Foot to 35 Foot),
NOTICE
has a unique assembly number and assembly part numbers.
1. Lay the Axle flat on the ground (A).
2. Mount both tires (B).
3. Assemble the upper arm weldments to the axle (C).
4. Assemble the upper pully cross member to both arms. Make sure the pulley
is facing the axle and the horizontal edge of the bracket faces down. This will
position the cable anchor on the correct side (D).
5. Assemble the upper cross braces (E).
6. Using the upper arm pin, assemble the Transport Slide. Secure the arm pin with
two cotter pins on either end (F).
7. Assemble the lower arm weldments to the axle (G).
8. Assemble the lower cross braces (H).
9. Tighten all of the fasteners.
USC CONVEYORS
HIGH VOLTAGE ~ Always disconnect the power source
before working on or near the control panel or lead wires.
HIGH VOLTAGE ~ Use insulated tools when making
adjustments while the controls are under power.
Permanent installation may require additional electrical cords,
since each installation is unique.

Installation

Section
B
Page 17