Table of Contents
Advertisement
The following steps outline the initial set-up of your Tube Series Conveyor:
1. Clear the area of bystanders, especially small children, before starting.
2. Be sure there is enough clearance from overhead obstructions and power lines
or other equipment to move the machine into its working position.
3. Attach the Conveyor to an appropriate towing vehicle.
4. Move conveyor as near as possible to desired position.
5. Set the park brake on the towing vehicle before dismounting.
6. Unhook the unit from the towing vehicle.
7. Use the winch to raise the machine so it clears the truck, trailer or wagon.
8. Place chocks in the front and rear of each wheel.
9. It will be necessary to stake or weight the intake end to prevent upending when the
machine is emptying.
10. Review the Workplace Safety Diagram for your model prior to starting work.
Follow all setup instructions and do not allow any unauthorized people into the
working area.
11. Have a certified electrician provide power to the conveyor. Provide convenient shut-
down switches and comply with local electrical codes. The conveyor may also be
plugged directly into a USC seed treater control panel.
12. Reverse the above procedure when removing the machine from its working
position.
USC CONVEYORS
CONVEYOR SET-UP
Ensure that the seed treater panel and the conveyor are rated for
the same power before plugging the conveyor into the seed treat-
er panel.
Page 57
Advertisement
Table of Contents
