Section E; Troubleshooting - USC SS16 Operator's Manual

Section

Troubleshooting

E
Below is a table describing the most frequent problems and solutions with the Tube
Series Conveyor. For further assistance, contact your authorized dealer.
Problem
Conveyor will not run.
Belt edge fraying.
Low conveying capacity.
Page 66
USC CONVEYORS
Possible Cause
1. Not turned on.
2. Conveying belt loose.
3. Drive belt loose.
1. Belt not aligned.
1. Angle too steep.
2. Slow operating speed.
3. Conveyor belt slipping.
4. Drive belt slipping.
Solution
1. Start power source or
turn on power.
2. Tighten and align belt.
3. Tighten drive belt.
1. Align and tension belt.
1. SS16, TS25 Reposition
o
with angle at 30
Reposition with angle
o.
less than 40
2. Increase operating
speed.
3. Tighten belt.
4. Set drive belt tension.
. TS35