Section F; Maintenance - USC SS16 Operator's Manual

Table of Contents

Advertisement

Section

Maintenance

F
Proper maintenance of the Tube Series Conveyors is critical for peak performance,
reliability and accuracy of this system. The following is a guideline for the type of
maintenance and servicing that should be performed on this unit. Your environment
and uses may require additional maintenance and service beyond this list to assure
a reliable and safe unit. The operator of this unit has ultimate responsibility to identify
areas of concern and rectify them before they become a hazard or safety issue.
There is no substitute for a trained, alert operator.
Use an SAE multipurpose high temperature grease with extreme pressure (EP)
performance. Also acceptable is an SAE multipurpose lithium-based grease.
• Use a Maintenance Checklist to keep record of all scheduled maintenance.
• Use a hand-held grease gun for all greasing.
• Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
• Replace and repair broken fittings immediately.
Your machine can operate at top efficiency only if clean lubricants are used. Use clean
containers to handle all lubricants. Store them in an area protected from dust, moisture
and other contaminants.
If fittings will not take grease, remove and clean thoroughly.
NOTICE
Also clean lubricant passageway. Replace fitting if necessary.
Page 68
USC CONVEYORS
Do not put this unit into operation with any questionably
maintained parts. Poor performance or a hazard may occur.
Do not use compressed air or water under pressure to clean any
of the components of the USC equipment.
Failure to maintain the proper belt tension will cause the belt to
slip. This will damage the belt and head drive pully. If the belt is
not tracking correctly, it can ride along one edge causing the belt
to fray and damage the belt splice. Either problem will cause the
belt to burn or wear out prematurely.
GREASING
Storing Lubricants

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts25Ts35

Table of Contents