Electric Winch Installation 20 To 35 Ft - USC SS16 Operator's Manual

ELECTRIC WINCH INSTALLATION INSTRUCTIONS
ELECTRIC WINCH AND CABLE KIT INSTALLATION (20 - 35 FT CONVEYORS)
FOR 20FT THROUGH 35FT CONVEYORS
If electric winch kit was ordered at the same time as the conveyor,
NOTICE
steps 1 through 4 will not be necessary.
STEP 1:
LOWER CONVEYOR UNTIL SLIDE IS AGAINST UPPER STOP,
WHEN FULLY LOWERED WINCH CABLE SHOULD BE SLACK.
1. Lower conveyor until slide is against upper stop. When fully lowered winch cable
should be slack.
STEP 3:
REMOVE COTTER PIN AND PULLEY PIN, REMOVE CABLE.
LAY PULLEY AND PIN TO THE SIDE FOR LATER RE-INSTALLATION.
2. Once the cable is slack, remove cable clamps and cable from anchor.
STEP 3:
REMOVE COTTER PIN AND PULLEY PIN, REMOVE CABLE.
LAY PULLEY AND PIN TO THE SIDE FOR LATER RE-INSTALLATION.
3. Remove cotter pin, pulley pin and the pulley from the upper cross member.
Set aside for re-installation later.
STEP 2:
STEP 2:
ONCE CABLE IS SLACK, REMOVE CABLE CLAMPS AND CABLE FROM ANCHOR.
ONCE CABLE IS SLACK, REMOVE CABLE CLAMPS AND CABLE FROM ANC
Page 30
USC CONVEYORS