Table of Contents
Advertisement
Section
Transporting
D
It is recommended that the Tube Series Conveyor be attached to an appropriate
towing vehicle whenever it is moved. Follow this procedure when attaching to or
unhooking from a towing vehicle:
1. Make sure that bystanders, especially small children, are clear of the working area.
2. Be sure the conveyor wheels are chocked.
3. Be sure that there is sufficient room and clearance to back up to the machine.
4. Align the drawbar of the towing vehicle with the hitch of the Conveyor while backing
up.
5. Set the park brake before dismounting.
6. Lower conveyor to lowest position.
7. Place hitch pin on conveyor to the lowest hole.
8. Align the hitch to the drawbar and install a hitch pin with a retainer (not supplied).
9. Remove chocks from machine wheels.
10. Move to new location.
11. Reverse the above procedure when unhooking.
12. Removal of the most forward pin will allow the conveyor to pivot on to the hitch
plate so the hitch plate can be used as a base.
Page 64
USC CONVEYORS
ATTACHING AND UNHOOKING
Advertisement
Table of Contents
