1. Check the conveyor belt tension and alignment.
2. Grease conveyor bearings.
A. Two bolt flanged bearings, tail roller bearings right and left (2 locations).
B. Two bolt flanged bearings, drive roller bearings right and left (2 locations).
3. Remove guard and check the drive belt tension and alignment. The belts will
deflect approximately 1/4 to 1/2 inch when properly tensioned.
4. Wipe down the motor casing with a damp cloth making sure to remove all dust
that may have collected since the last maintenance date. Record the cleaning on
the company required documents
USC CONVEYORS
CONVEYOR SERVICING INTERVALS
Every 40 hours or Weekly
Page 69