Removal Steps - Siemens SIMATIC S7-400 CP 440 Installation And Parameter Assignment

4.2.2

Removal steps

To remove the communication processor from the rack, proceed as follows:
1. Undo the screws at the top and bottom of the module.
2. Tilt the module upward and remove it.
3. Replace the filler panel over the empty slot.
Point-to-point connection CP 440 Installation and Parameter Assignment
Manual, 09/2007, A5E00057742-03
www.gkbpx.com
Mounting the CP 440
4.2 Mounting and Dismounting the CP 440
该文档是极速PDF编辑器生成，
如果想去掉该提示,请访问并下载：
http://www.jisupdfeditor.com/
63