Hanseatic HWM714A3D User Manual page 92

Seite EN-42 Troubleshooting table
Problem
Colours of the laundry
have faded.
Problem
Appliance does not
work.
Wash cycle does not
start.
Appliance is not
receiving water.
Water is not being
pumped.
Water is draining even
though the appliance
is not pumping.
Water is leaking.
(Appliance is leaking).
Wash result is not satisfactory
Possible causes
Detergent contains bleaching
agent.
Stain remover or something
similar was used.
Malfunction
Possible causes
Mains plug is not sitting properly in
the socket or is not plugged in.
Socket has no voltage.
Fuse is not intact.
No wash cycle set.
Loading door is not closed
properly.
Cycle was not started.
Valve is closed.
Door is not closed properly.
Inlet hose is bent.
Inlet hose is clogged.
Filter on inlet is clogged.
Outlet hose is clogged or bent.
Outlet hose is too low.
Inlet or outlet hose is not screwed
on tightly enough.
Lint trap not closed properly.
Solutions, tips
Use colour freshener if necessary
(available at chemist's). In future,
use detergent without bleaching
agent.
Solutions, tips
Plug it into the socket properly.
Check fuse; switch on if
necessary.
Replace fuse.
Set wash cycle.
Close loading door properly.
(A 'click' must be heard.)
Press button (7).
Open valve.
Close door properly.
Check inlet hose; dismantle if
necessary and re-align.
Clean inlet hose filter; see page
EN-33.
Clean inlet filter; see page EN-33.
Check outlet hose; dismantle if
necessary and re-align.
Place outlet hose higher.
Screw down inlet or outlet hose
down tighter.
Close lint trap properly; see page
EN-34.