Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Final Checks
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier, and then turn on the ovens.
Check the oven fans start to turn and that the ovens heat up.
Final Fitting
Fitting the 2-piece Plinth
Fit the inner plinth to the bottom front of the cooker using
the 5 screws provided (3x M5 screws in the lower edge, 2x
No.8 screws in the each end) (Fig. 10.18).
Loosen the 2 screws in the front of the inner plinth.
Locate the 2 slotted brackets on the inside of the outer plinth
onto the 2 screws (Fig. 10.19).
Note: To aid the fitting of the outer plinth, we advise that you
open the doors and place the wings of the outer plinth over
the side panels at approximately a 45 º angle (Fig. 10.20). This
will aid location of the outer plinth onto the retaining screws.
Using a suitable screwdriver through the slots in the outer
plinth, tighten the 2 screws to secure.
The height of the outer plinth can be adjusted by loosening
the 2 retaining screws and sliding it up or down to suit and
then retightening the screws.
Fitting the Splashback
Position the splashback on the rear of the hotplate and secure
with the screws supplied.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
INSTALLATION
Inner plinth
Outer plinth
Side panel
33
M5 (large screw)
No.8 (smaller screw)
Inner plinth
Outer plinth wing
Fig. 10.18
Fig. 10.19
Fig. 10.20
Advertisement
Table of Contents
