Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have finished.
Fig. 10.11
Fig. 10.12
Fig. 10.13
INSTALLATION
Conversion to Another Gas
If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
instructions.
Fitting the Handles
The handles will require fitting as follows:
Remove the existing M5 screws from the doors. Keep them in
a safe place (Fig. 10.11).
Position the handle (Fig. 10.12) and screw in the M5 screws
(Fig. 10.13).
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position, taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
30
Advertisement
Table of Contents
