Table of Contents
Advertisement
3.2. Switching the Monitor On
Press and hold the R Button for one second to switch the monitor ON (refer to
Buttons). The flash screen appears (as shown in
warm-up routine, which lasts approximately 30 seconds. During the warm-up, a countdown timer
appears in the top right corner of the display.
NOTE: The LCD backlight illuminates green and remains ON during warm-up. At the
completion of the warm-up cycle, the LCD backlight automatically switches off.
3.2.1. Instrument Identification
During warm-up, the LCD identifies the serial number, software version, battery status, and
calibration gas information. The monitor will also indicate the number of completed leak
inspections ready to be transferred to the tablet application. These are shown as INS JOBS, as
illustrated in
Figure 4: Monitor Identification
3.2.2. Filter Check/Flow Fault Test (Daily Check Only)
To ensure the monitor operates properly, always make sure the filters are in place and in good
condition, and perform a regular leak check. The monitor will prompt the user once every day to
perform these checks before it completes the warm-up sequence.
64171LMP
Revision 3
Figure 3: Flash
Figure 3: Flash Screen
Display.
Figure 4: Monitor Identification Display
PS200-LMP
PORTABLE GAS MONITOR
Figure 2: Function
Screen) and the monitor begins its
7
Advertisement
Table of Contents
