Table of Contents
Advertisement
To set the cables in the connectors,
4
press on the blue part with pliers.
6
The GNSS modules have the antenna integrated into the module and in its upper part,
in order to avoid that the structure of the center does not adversely affect the perfor-
mance of the communications.
For the correct operation of the system and to have good radio communication, it is very
important that the GNSS module be installed on the last tower and at least 2 meters above
the Pivot metal structure. With this, a correct position reading and communication between
the GNSS module and the Coordinator are achieved.
IMPORTANT
In the event that the Pivot has sprinklers
installed directly on top of the main
pipe, the installation height of the GNSS
module must be increased enough so
that the module does not receive direct
water from the spray.
LOCATION SENSORS
The AgroBee-L GNSS module incorporates the GPS-GLONASS receiver inside it. For the correct
operation of the system and for greater precision provided by the module when determining the
geographical position, it is very important that the antenna installed in the module is as perpen-
dicular as possible to the ground.
Place the whole assembly on top of
5
a post.
7
User's manual | AgroBee-L ·
Advertisement
Table of Contents
