Table of Contents
Advertisement
When configuring an AgroBee-L GNSS module, you must enter the geographical coordinates
of the centre point of the pivot and of the starting or reference point 0°, if it is circular, as para-
meters.
If the pivot is linear, the centre point will be the left end, and the starting point will be the right
end. These coordinates are given in degrees, minutes, and seconds, and can be entered through
the Module Reader or the Agrónic to which said module is linked.
Through the parameters entered and once the module has determined its geographical
position, this GNSS module can provide us with the following values:
• Measures delivered:
‒ Angle with respect to the
starting or reference point of 0°
(clockwise)
‒ Angle respect to the initial point
or reference point of 0° (counter-
clockwise)
‒ Distance from the centre point
‒ Angle of the reference point 0°
with respect to geographic North
The AgroBee-L GNSS module has a 4 Ah internal battery and three 5 W solar panels that are
delivered along with the module.
This module is always active and collects data from the satellites it has in view. This allows it be
precise when pinpointing its position, the maximum that the system allows, about +/- 3 metres.
The navigation system's antenna is integrated inside the module.
Option 1 (GNSS function only) does not present any kind of wiring, so, in this case, it is not
necessary to make any connections.
In Option 2, the wiring is logically necessary, since there are connections for the latch solenoids
and analog and digital sensors.
Technical characteristics
Power supply
Power supply:
Energy consumption: GNSS
2
· User's manual | AgroBee-L
GNSS:
Solar: 3 x 5W → 3,6V
Average consumption:
90 mW
Panels plus 4000 mAh Ni-MH battery
CAUTION!
When handling the
battery pack, take the following
precautions: do not short-circuit,
disassemble, or deform it, do not heat
or burn it, and do not place the
battery pack near any open flame.
Advertisement
Table of Contents
