Table of Contents
Advertisement
Settings
For any AgroBee-L module to enter the correct operating mode, you must have an Agrónic
controller (Agrónic 2500, Agrónic 5500 and Agrónic Bit Con) with the AgroBee-L option installed,
which includes the internal coordinator and an antenna with 10 metres of cable. This can be
verified by doing the following in the controller:
Consult
Press the
key to enter the main menu. Use the
within the menu. Use the
to the previous hierarchy's menu.
You will see the following options in the main menu:
• Consult controller
• Consult communications
• Consult digital output
• Consult digital and analog inputs
• Communication parameters
• Input-Output parameters
• Output manual
• Sectors manual
• Various parameters
Once the AgroBee-L module is linked with an Agrónic, all the consultations and
NOTE
parameters are accessible through the Agrónic.
10
· User's manual | AgroBee-L
Communication
In the same way, a module must be configured to
communicate with the Agrónic with which you want to
associate it. To do this (if the module is not already confi-
gured at the factory) you must use the Module Reader (or
Agronic Radio Reader, LAR) consisting of a screen and four
keys, that is connected to the AgroBee-L module through
the only connector visible on the inside.
A wireless module reader is also available that allows you
to perform functions without the need for a cable. Consult
the wireless AgroBee Reader manual to learn about the
steps to link it to the controller.
key to enter the selected menu option. Use the
AgroBee-L
-
+
and
keys to change the options
Status: Correct
c c
key to return
Advertisement
Table of Contents
