Table of Contents
Advertisement
CONTROLLER QUERY OF AN AGROBEE-L MODULE
General query menu of the module, where the following parameters are displayed:
• Module and serial number:
‒ Module: It refers to the module number (1 to 20) according to the established
communication parameters. There can only be one same module number for each
Agrónic.
‒ Serial number: Information regarding the controller. It comes from the factory.
• Battery voltage and solar panel:
‒ Vbat: Battery voltage:
∙ Panel+Supercapacitors: Maximum value: 3.4V; Minimum value: 2.2V
∙ Panel+Battery: Maximum value: 4.2V; Minimum value 3.4V
‒ Vsol: Voltage of the solar panel
These same data can be viewed in the Agrónic by accessing "Consult - Communications -
AgroBee," as you will see in the next section.
CONSULT COMMUNICATIONS IN AN AGROBEE-L MODULE
Communication consultation menu of the module, where the following parameters are
displayed:
• Transceiver: Type of emitter installed in the module. It tells you if the module works at
868MHz/433MHz or 915MHz
‒ RN2483 (868MHz/433MHz)
‒ RN2903 (915MHz)
• Band and transmission mode:
‒ Band: 868MHz, 433MHz, 915MHz
‒ Transmission Mode: 1 to 18 (mode 5 will be set by default)
• Consult parameters of the communication type:
‒ Channel: 1 to 13
‒ Network code: It is usually the associated Agrónic serial number
‒ BW: Bandwidth of the radio modulation (125KHz, 250KHz, 500KHz). It is set according to
the transmission mode chosen in the communication parameters.
‒ Radio modulation factor: SF7, SF8,..., SF12. It is set according to the transmission mode
chosen in the communication parameters.
‒ Communication status:
∙ Status message:
- Correct Communication
- Network error
11
User's manual | AgroBee-L ·
Advertisement
Table of Contents
