Table of Contents
Advertisement
‒ It does not close: the output state remains as it is
‒ Close immediately: all outputs close immediately upon losing communication with the
Agrónic
‒ Close 15 min: all outputs close after 15 minutes of the module being unable to
communicate with the Agrónic.
To modify any of the sub-menu's fields, press
-
mode. Use the
c c
. Press
to exit the menu and access the previous hierarchy's menu, which will change the para-
meters and let them take effect.
IMPORTANT
The detailed input/output parameters can also be entered in the Agrónic. In this case, the
module will receive the parameters upon communicating with it. If not, and these parameters
have been changed through the Module Reader in the same module, the Agrónic will receive and
update said parameters.
To modify these parameters from the Agrónic, you must access "Parameters – Installer –
Communications – AgroBee – Module." Specify the module number in the Agrónic network in
question, after which you will see the following screens to modify the detailed parameters (see
the Agrónic manual in question for more details).
AgroBee-L 15
Pivot type: circular
AgroBee-L 15
Sensor 1 Activate: yes
Timing: 5'
Voltage: 12 Vdc
Voltage time: 250 ms
AgroBee-L 15
Latch tension: 12 Vdc
Latch valve: 2 wires
+
and
keys to set the desired value. Confirm with
AgroBee-L 15
Central point
Latitude
041 º 37 ' 39.06 " North
Longitude
001 º 00 ' 20.24 " East
AgroBee-L 15
Sensor 2
Timing: 5'
Voltage: 12 Vdc
Voltage time: 250 ms
. The screen will display that you are in edit
Activate: yes
or dismiss with
AgroBee-L 15
Initial point
Latitude
041 º 37 ' 43.23 " North
Longitude
001 º 00 ' 28.24 " East
AgroBee-L 15
Action error: Nothing
General module: no
Stop sectors: no
User's manual | AgroBee-L ·
c c
17
Advertisement
Table of Contents
