Estimated Battery Life - Progres AgroBee-L Manual

Hide thumbs Also See for AgroBee-L:
Table of Contents

Advertisement

Estimated battery life

Battery life with standard communication rate mode 5: 60 seconds
Type
Panel + Battery 4000mAh Ni-MH
(1): The duration of the battery with its maximum charge and without recharging. This case can occur when the solar panel
does not recharge the battery (with clouds or fog).
Battery life is approximate since there are several factors that can affect consumption. Frequent
reading of digital sensors (when counters are configured) shortens the duration. Likewise, if a
priority mode rate is set, the battery life will decrease.
Conversely, for the H2O model, if a higher sensor reading rate is selected, the battery life will
increase.
Battery replacement you do not need to replace any battery in any case, since the power
supply of the modules is based on a system of supercapacitors.
TURNING OFF THE CONTROLLER
If a module does not find the Agronic with which it communicates, said module will follow its
own course, and will send data every certain time, according to the established timing. However,
in order to avoid possible collisions and/or interferences, the module will slightly offset the
pre-established communication time. The consumption of an AgroBee-L module is practically
unchanged due to the fact that it is not connected to any Agrónic.
Updating the AgroBee-L module software
Whenever there is a new software version for an AgroBee-L module, the user can update it. To
do this, you must perform the following steps:
• Have a computer with an Internet connection and a USB to miniUSB cable.
• Download the program "AgronicUpg" + "drivers" + update file (dfu) by typing this address bit.
ly/actualizaragronic into the computer's browser.
• Select and download the AgroBee-L folder.
• Go to the module and turn it off using the switch.
• Place the other switch inside the module in the recording position (by default, it is in the
'Normal' position).
• Connect the USB to the computer and the miniUSB to the module.
• Start up the module using the ON/OFF switch.
(1)
GNSS
< 3 days
User's manual | AgroBee-L ·
19

Advertisement

Table of Contents
loading

Table of Contents