Transaction Information; Calibration Logs; Alarm Logs - Honeywell Enraf Operation Manual

2.3.9.1.1 Transaction information

2.3.9.2 Calibration Logs

2.3.9.3 Alarm Logs

Part No.: 44200004 - Revision 2
Controller Information
The details of any transaction can be viewed by going to that transaction
and pressing OK. After every prover run cycle in calibration of meter mode
the following parameters will be logged after completing the prover run
Transaction ID

Stop Transaction date and time

Cycle count

Sweep time

Alarm information

Sensor Pair

Device Serial Number

Transaction record version

The details of any transaction can be viewed by going to that transaction
and pressing OK. After every prover run cycle in prover calibration mode
the following parameters will be logged after completing the prover run.
The calibration log contains the following information:
Date and time

Sweep time in seconds

Average volume

Repeatability

There are no units displayed for the average volume as they will be
known by the user and to avoid complications if the units specified in the
Configuration/Device/Units menu are changed.
The Alarm log forms a permanent record of the same information that
can be viewed while an alarm is active from the Diagnostics/Active
Alarms screen. This information consists of the date and time stamp and
descriptive text.
SVP Controller Operation Manual 2-17