Honeywell Enraf Operation Manual page 52

T2
WATER
SUPPLY
Figure 4-7: Water Draw Plumbing Diagram
4-10
Calibration
In calibration mode alarms will be generated as per the configuration, and
the run permissive signal from the flow computer or the run prover test
signal will be ignored. The operating mode of the prover will be saved in
NVM so that the mode will be restored if power is turned off while in Prover
Calibration mode.
To exit calibration mode navigate to the Exit Calibration Mode menu and
press OK.
A copy of Table 1 can be used to enter water draw data.
VENT
Td
V2
V1
V6
Ttm
T3
TEST MEASURE
SVP Controller Operation Manual
VENT
V3
FLOW
S S
SV1
Tp
T1
Pp
P1
SVP
CONTROLLER
V4
SV2 V5
WASTEWATER
CATCH
CONTAINER
Part No.: 44200004 - Revision 2
Ta
T4