Page 1
THANK YOU We appreciate the trust and confidence you have placed in Everbilt through the purchase of this automatic pool cover pump. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Table of Contents Table of Contents ............2 Installation ..............6 Performance ..............2 Operation ............... 7 Safety Information ............2 Airlock ................7 Warranty ................. 3 Care and Cleaning ............7 Pre-Installation .............. 4 Troubleshooting ............9 Performance GPH of Water @ Total Feet Of Lift Max.
Safety Information (continued) CAUTION: Know the pump and its applications, limitations, IMPORTANT: Ensure the electrical power source is and potential hazards. adequate for the requirements of the pump. CAUTION: Secure the pump to a solid base. This will aid in IMPORTANT: Before using the pump, check the hose for keeping the pump in a vertical orientation.
Pre-Installation APPLICATION This automatic submersible utility pump is designed for water removal applications. Pump water only with this pump. It can automatically drain or remove water from the following: swimming pool covers, sinks, window wells, boats, low spot in yards, or other flooded areas.
Page 5
Pre-Installation (continued) PACKAGE CONTENTS NOTE: The adapter is not shown to scale. Part Description Pump 3/4 in. garden hose adapter Base GFCI with 25 ft. cord SPECIFICATIONS Power supply 115V, 60 HZ., 10 Amp Circuit Liquid Temp. Range 32°F to 95°F(0°-35°C) Discharge 1 in.
Installation Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug CAUTION: the pump and allow time for it to cool after periods of extended use. Connecting a 3/4 in. garden Connecting a adapter hose or 1-1/4 in.
Operation NOTE: Make certain you unwind the garden hose completely. Kinks in the hose will restrict the pump, preventing it from priming, which is the first step to pumping water. This pump has water detector sensors. As long as the water level is over 2 in., the pump will automatically start operating.
Page 8
Care and Cleaning (continued) TO CLEAN THE WATER SENSOR HOUSING NOTE: Unplug the power cord. Simple clean the pump Put the pump upside down and flush the bottom of the filter base with clean water. Deep clean the water sensors and impeller Pull the snap fittings on the pump housing and Pull the cap up along the pump housing.
Care and Cleaning (continued) Clean the debris and contamination around the To clean the pump clogged with debris. sensor probes. Remove the screws (4) and take out the volute (3) from the pump and clean the debris on the impeller (1). Reassemble the volute (3), water sensor housing and sensor ...
Page 10
Questions, problems, missing parts? Before returning to the store call Everbilt Customer Service 8 a.m. – 6 p.m., EST, Monday-Friday 1-844-241-5521 HOMEDEPOT.COM...