Charging Rechargeable Batteries - Denso BHT-1505B User Manual

Barcode handy terminal
Table of Contents

Advertisement

BHT-1500B Series

6.2 Charging rechargeable batteries

When using rechargeable batteries, it is possible to charge with the BHT main body as follows.
Charging via the communication unit or the
charger
Place the BHT on the communication unit or the
charger. The LED on the BHT illuminates in red to
indicate that charging has begun. The LED on the
BHT will change to green when charging is
complete.
Indicator LED
Communication Unit
CU-AR1-15, CU-AL1-15
CU-AU1-15
Battery charger
CH-A4-15
The charging time is approximately 5 hours.
To ensure optimum charging of all rechargeable batteries, charge them using the genuine battery charger for
the battery brand.
When using alkaline dry cell batteries, ensure that the battery selector switch is set correctly. Do not recharge
alkaline dry cell batteries.
− Note −
If the LED does not illuminate, it is impossible to charge the battery. Check the following items.
• Check that the battery selector switch has been set properly.
• Check that the BHT has been placed in the communication unit or charger properly.
If the LED does not illuminate in red, remove the BHT and check the charger terminals. Then, position
the BHT again.
• If the battery is charged with the Direct cable connected, it may be impossible to charge the battery
depending on the point at which the cable is connected. Check, therefore, the port to which the cable
is connected.
If the LED flashes in red, it is impossible to charge the battery. Check the following items.
(The red LED starts to flash one minute after charging starts.)
• Check that the rechargeable batteries specified by DENSO WAVE have been loaded in the BHT
properly.
• Check that the rechargeable battery and BHT unit are not contaminated.
If any contamination is found to be on either of these items, wipe it off before.
• Place the powered-off BHT in the communication unit while holding down the [SCAN] key for at least 3
seconds, to force the BHT into the charge mode.
The LED indicator illuminates in ORANGE when the BHT starts charging.
• If an old rechargeable battery which has been charged repeatedly is in use, replace it with a new one.
• Check that the battery charging temperature is not exceeded. Normally, the battery charging
temperature range is narrower than that of the service temperature. If the battery is excessively cold
or hot, the battery performance will be adversely affected resulting in an inability to be recharged.
198

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bht-1505bb

Table of Contents