Graco Therm-O-Flow 200 Instructions Manual page 28

EasyKey Display Screens
Screen Setting
1 Language English,
See (F . 16)
IG
Number
Zones
Change
Setpoint
Tempera-
ture Units
Heat Soak Numeric
2 Units
See (F . 17)
IG
7-Day
Timer
Pump Inac-
tivity
External
Pump
Enable
Runaway
Rate
Specific
Gravity
3 Month
See (F . 18)
IG
Day
Year
Time
Password
Screen
Saver Time
28
Table 7: Advanced Setup Screens
Selection
Language displayed. The language is set at factory.
Spanish,
German,
French,
Japanese,
Chinese,
custom
6+8 / 6+4 / The number of zones in system is set at the factory.
8+4 / 6+6 /
8+8
Yes/No Select Yes or No to allow operator to change setpoints from the Zone Run
screen.
°F/°C Select desired temperature units.
Enter time (in minutes) to delay air motor start after all zones reach tempera-
ture setpoints.
cycles/ Select desired units. Affects units used for Run screen job totalizers and
gallons/ Report screen grand total volume.
liters/
lbs/
kg
On/Off (Enable / Disable 7 day timer).
Yes/No If pump does not move for 2 hours, zones switch to setback temperatures. If
2 more hours pass without pump movement, system shuts off. Select Yes or
No.
On/Off Allows external device to control pump.
Numeric Enter speed (cycles/min) at which air motor will be shutdown, to prevent run-
away.
Numeric Used to determine units when weights are selected (Lbs / Kgs).
Numeric Select current month (1-12).
Numeric Select current day (1-31).
Numeric Select current year (4 digits).
Numeric Enter hours (0-23) and minutes (0-59).
Numeric Is only used to enter Setup mode. Default is 0, which means no password is
required to enter setup. To set a password, enter a number (1–9999).
Numeric Enter minutes (1-99) for screen to be inactive before screen saver turns on
(screen dims). Press any key to restore. Default is 0 (screen saver off).
Description
311208P