Ordering Information; Device Repair And Return - UTC Fire and Security Det-Tronics X Series Instructions Manual

Flame detection / releasing system with flame detectors

Hide thumbs

Table of Contents

4. Loosen the captive screw at the bottom of the front

panel of the module and slide it out of the mounting

rack.

5. Return to the factory for repair as instructed in the

"Repair and Return" section of this manual. Replace

with a serviceable controller.

When replacing a controller, be sure that the

rocker switches of the replacement are the same

as the original.

DEvICE REPAIR AND RETURN

Prior to returning devices or components, contact

the nearest local Detector Electronics office so that

an RMI (Return Material Identification) number can

be assigned.

A written statement describing the

malfunction must accompany the returned device or

component to expedite finding the cause of the failure,

thereby reducing the time and cost of the repair. Pack

the controller circuit boards using sufficient packing

material in addition to an anti-static bag or aluminum-

backed cardboard as protection from antistatic

discharge.

Return all equipment transportation prepaid to the

Minneapolis location.

1.3

NOTe