MasterCraft 55-6857-6 Operating Manual page 4

Only use recommended accessories. Consult this Operating Manual for
recommended accessories. The use of improper accessories may cause risk of injury
to yourself or others.
Never stand on the tool. Serious injury could occur if the tool is tipped or if the
cutting tool is unintentionally contacted.
Always wear eye protection. Any power tool can throw foreign
objects into the eyes and could cause permanent eye damage.
ALWAYS wear Safety Goggles (not glasses) that comply with ANSI
Safety standard
impact-resistance lenses. They ARE NOT safety glasses.
NOTE: Glasses or goggles not in compliance with ANSI Z87.1 can also present a
danger if the glasses/goggles break.
Check for damaged parts. Before further use of the tool, a guard or other part that is
damaged should be carefully checked to determine that it will operate properly and
perform its intended function-check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that may affect the
operation of the tool. A guard or other part that is damaged should be properly
repaired or replaced.
Never leave the tool unattended while the power is "on". Turn the power "off".
Do not leave the tool until the blade comes to a complete stop and the mitre saw is
unplugged.
Do not over reach. Keep proper footing and balance at all times.
Maintain tools with care. Keep tools sharp and clean for optimum performance.
Follow instructions for lubricating and changing accessories.
CAUTION: Do not attempt to operate this tool until you have thoroughly read
all instructions, safety rules and warnings. Failure to comply can result in fire, electric
shock, or serious personal injury. Retain the Operating Manual and review frequently
for future reference.
WARNING: Dust generated from certain materials can be hazardous to your
health. Always operate saw in well-ventilated area and provide for proper dust
removal.
WARNING: The operation of any tool can result in foreign objects being
propelled into your eyes, resulting in severe eye damage. When operating power tool,
always wear safety goggles or safety glasses with side shields and a full-face shield
when needed.
ELECTRICAL SAFETY
Double insulated
This compound mitre saw is double insulated to provide a double
thickness of insulation between the operator and the electrical system
of the tool. All exposed metal parts are isolated from the internal metal
motor components with protecting insulation.
Z87.1 Everyday eyeglasses have only
4