Glossary Of Woodworking Terms - MasterCraft 55-6857-6 Operating Manual

GLOSSARY OF TERMS FOR WOODWORKING
•
Arbour: The revolving shaft on which a blade or cutting tool is mounted.
•
Arbour Lock: Allows the user to stop the blade from rotating while tightening or
loosening the arbour screw during blade replacement or removal.
•
Bevel Cut: A cutting operation made with the blade at any angle other than 90° to
the mitre table.
•
Chamfer Cut: A cut removing a wedge
of the end) is angled at other than 90°.
•
Compound Mit re Cut: A cut made using both a mitre angle and a bevel angle at
the same time.
•
Cross cut: A cutting operation made across the grain of the work piece.
•
Flange: A ring or collar on the end of a spindle or arbour that permits other
objects, such as a blade, to be attached to it.
•
Freehand Cut: Performing a cut without using a fence, mitre gauge, fixture, work
clamp, or other pro
during the cut. Do not perform any operation free ha
wherever possible.
•
Gum: A sticky, sap-based residue from w
•
Kerf: The material removed by the blade in a through cut or the slot produced by
the blade in a non-through or partial cut.
•
Kickback: A hazard that can occur when the blade binds or stalls, throwing the
work piece back toward operator.
•
Mitre Cut: A cutting operation made with the blade at any angle other than 90° to
the fence.
•
No Hands Zone: The area between the marked lines on the left and right side of
the mitre-table base. This zone is identified by No Ha
marked lines on the mitre table base.
•
Non-Through Cuts: Any cutting operation where the blade does not extend
completely through the
•
Resin: A sticky, sap-based substance that has hardened.
•
Revolutions Per Minute (RPM): The number of turns completed by a spinning
object in one minute.
•
Saw Blade Path: The area over, under, behind, or in front of the blade, as it
applies to th e work piece: that area which will be or has been cut by the blade.
•
Set: The distance that the saw blade tooth is bent (or set) outward from the face
of the blade.
•
Throat Plate: A plate inserted in the Mitre Saw's table that allows for blade
clearance.
•
Through Saw ing: Any cutting operation where the blade extends completely
through the thickness of the work piece.
•
Work Piece or Material: The item on which the cutting operation is being done.
The surfaces of a work piece are commonly referred to as faces, ends, and
edges.
per device to keep the work piece from twisting or moving
thickness of the work piece.
from a block of wood so the end (or part
nd. Use a clamp or vise
ood products.
nds Zone symbols inside the
8