Table 4-11 Register Of Protection Status - Prodigit 3302F Mainframe Operation Manual

Hide thumbs

Table Of Contents

Table of Contents

58 PRODIGIT

BIT ID

bit 0

bit 1

bit 2

bit 3

[STATe：] CCR {AUTOR2}

Command Syntax:

[STATe：] CCR {AUTOR2} {；NL}

Purpose: Set the CC MODE RANGE, forcing RANGE II operation if required.

Description: Swaps the unit between AUTO RANGE and RANGE II. AUTO RANGE

[STATe：] POLAR {POSNEG}

Command Syntax:

[STATe：] POLAR {POSNEG} {；NL}

Purpose: Sets the polarity displayed by the voltage meter.

Description: The voltage read-out can be set to POS for positive, and NEG for

[STATe：] START

Command Syntax:

[STATe：]START {；NL}

Purpose: Set for Load to begin the test.

Description: Begins the test, according to the TEST CONFIG(TCONFIG), the load

[STATe：] STOP

Command Syntax:

[STATe：]STOP {；NL}

Purpose: Stops the test, if one is in progress.

4.6.4.

SYSTEM functions allows the user to read the part number of the

Load modules and turn RS232 control ON and OFF. Commands are also

Available for storing and retrieving load set-ups saved in the memory of the

Mainframe. The mainframe has 150 separate memory locations. This is

Comprised of 15 memory BANKS with each bank having 10 STATES.

BANK(n)

STATE(m)

TOTAL STATE

BIT VALUE

0 = Off, 1 = Triggered