Table 4-10 Error Register - Prodigit 3302F Mainframe Operation Manual

Hide thumbs

Table Of Contents

Table of Contents

[STATe：] ERRor

Command Syntax:

[ STATe：] ERRor ？{；NL}

Purpose: Query if there are any errors flagged in the module.

Description:

1. ERR? : Read the register of ERR status. TABLE 4-10 shows the

Corresponding number of ERR status

2. Use command CLR to clear the register of ERR status to be"0"

BIT ID

BIT VALUE

bit 0~3

0 = Off, 1 = Triggered

bit 4

0 = Off, 1 = Triggered

bit 5

0 = Off, 1 = Triggered

[STATe：] NG？

Command Syntax:

[ STATe：] NG? {；NL}

Purpose: Query if the NG flag is displayed on this module

Description: Set command NG? to show the NG status. If the response is "0" the LED

of NG(NO GOOD) will be off. If the response is "1" the LED will be lit, showing

that the NG flag is present.

[STATe：] PROTect？

Command Syntax:

[ STATe：] PROTect?{；NL}

Purpose: Query the state of the protection register on this module

Description: 1.PROT? requests the status of the units protection register.

2. Use the command "CLR" to clear the register of PROT status to "0"

Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit1 Bit 0