Remote Control Command Descriptions - Prodigit 3302F Mainframe Operation Manual

4.6. Remote Control Command Descriptions

4.6.1.
SETTING functions are used to program sink values along with the operating
Mode. The user can also preset dynamic waveforms and set up OCP, OPP, OVP
& SHORT tests. The special parameters used for the 3340F/G series of LED
Simulators are also described in this section.
RISE
Command Syntax:
[ PRESet：] RISE {SP}{NR2}{；NL}
[ PRESet：] RISE ？ {；NL}
Purpose: Set and read the RISE SLEW-RATE
Description:
1. The definition of the RISE SLEW-RATE is the rate of current change from a LOW
level to a HIGH level when operating in dynamic mode. The settings of RISE and
FALL are completely independent.
2. The RISE command must include a number value otherwise the command will
not be valid.
3. The least significant number is the 4
4. Should a value be entered that is higher than what is possible then the 3302F will
automatically set its maximum value according the load module fitted.
5. The engineering unit is A/us for load modules 3310F, 3311F & 3312F.
The engineering unit is mA/us for load modules 3314F, 3315F, 333XF & 3340F/G
FALL
Command Syntax:
[ PRESet：] FALL {SP}{；NL}
[ PRESet：] FALL? {；NL}
Purpose: Set and read the FALL SLEW-RATE
Description:
1. The definition of the FALL SLEW-RATE is the rate of current change from a
HIGH level to a LOW level when operating in dynamic mode. The settings of
RISE and FALL are completely independent.
2. The FALL command must include a number value otherwise the command will
not be valid.
3. The least significant number is the 4th digit after the decimal point.
4. Should a value be entered that is higher than what is possible then the 3302F will
automatically set its maximum value according the load module fitted.
5. The engineering unit is A/us for load modules 3310F, 3311F & 3312F.
The engineering unit is mA/us for load modules 3314F, 3315F, & 333XF
3302F Mainframe Operation Manual 45
th digit after the decimal point.