Select Cell Constant - LaMotte 6 Series Manual

Meter
ON
OFF
Overview of TDS 6 Set-Up Menu

Select Cell Constant

It is possible to select a cell constant of K = 1.0, 10, or 0.1.
Use a cell of K = 1.0 for midrange measurements
Use a cell of K = 10 for high range measurements
(above 20 mS or 10 ppt).
Use a cell of K = 0.1 for low range measurements
(below 20 µS or 10 ppm).
The cell included with the meter has a cell constant
of K = 1.0.
1. Enter Advanced Set up.
2. Press or
LCD. Press ENTER button.
3. Press or
"10.0". Ensure the cell constant selected correspond
with the conductivity electrode that is being used
with the meter.
4. Press ENTER button to select. The meter will
return to the menu, [CELC].
5. Press
or
press CAL to exit to measurement mode.
Off
Press ON/OFF and MODE buttons keys
MODE
simultaneously for 2 seconds, release
Release ON/OFF button first then release MODE button
a second later.
A "StUP" indicator will appear for 1.5
seconds before showing the first menu.
button until [CELC] appears on the
button to select either "1.0", "0.1" or
button to move to the next menu or
%
25
° C
HOLD
ENTER