Erreka VIVO-M201 Quick Installation And Programming Manual
Hide thumbs
Also See for VIVO-M201:
- Installer manual (106 pages) ,
- Quick installation and programming manual (44 pages) ,
- Quick installation and programming manual (4 pages)
Table of Contents
Advertisement
Quick Links
VIVO-M201(M)
Quick installation and programming guide
This quick guide summarises the full installation manual. The full manual contains safety warnings and other
explanations that must be taken into account. You can download the latest version of this guide and the
installation manual in the "Downloads" section of the Erreka website:
http://www.erreka-automation.com
IMPORTANT
The options and functions described in this guide are applicable from the firmware version indicated on the
NOTE
circuit. As part of a process of continuous improvement, the firmware is subject to the incorporation of new
functionalities or their extension, and consequently to the generation of new versions not necessarily
compatible with the previous ones. Therefore, if your firmware version is lower than the one indicated in
this guide, some options and functions may not be available or may be different.
ELECTRICAL CABLING:
Element
A: Main power supply
B: Flashing light
C: Photocells (Tx / Rx)
D: Key switch
E: Operator
F: Antenna
Elements of the complete installation
Nº wires x section
2
3x1.5mm
2
2x0.5mm
2
2
2x0.5mm
/ 4x0.5mm
2
2x0.5mm
2
4x0.75mm
Coaxial cable 50k (RG-58/U)
Maximum length
30m
20m
30m
25m
20m
5m
English
5
Advertisement
Table of Contents
Related Manuals for Erreka VIVO-M201
Summary of Contents for Erreka VIVO-M201
- Page 1 This quick guide summarises the full installation manual. The full manual contains safety warnings and other explanations that must be taken into account. You can download the latest version of this guide and the installation manual in the "Downloads" section of the Erreka website: http://www.erreka-automation.com...
- Page 2 A 1 / A 2 o p e r a t o r connections: G1/G4 open G2/G5 close G3/G6 common, grey T: earth connection VIVO-M201: 230Vac/50Hz VIVO-M201M: 125Vac/60Hz (resistive) When using a single operator, connect it to cable connectors G1, G2 •...
- Page 3 Using radio cards This control board is factory set to use a two-channel receiver (e.g. IRRE2). This factory setting is modified if an RSD receiver is used and a permanent code is recorded (decoding through the board, DIP1 + DIP4 or DIP6 = ON). To recover the factory settings, insert the IRRE2 card and place DIP1 + DIP4 or DIP6 = ON.
- Page 4 Function and mode selection using SW2 (DIP1 = OFF) Modes and functions Option Effect DIP1 the flashing light comes on and the operation begins after a 3 second warning DIP2 Advance warning the flashing light comes on and the operation begins immediately step-by-step opening (the gate halts if a key device is enabled during opening, and closes if enabled again) DIP3...
Need help?
Do you have a question about the VIVO-M201 and is the answer not in the manual?
Questions and answers