Download Print this page
Erreka VIVO-D102 Quick Installation And Programming Manual

Erreka VIVO-D102 Quick Installation And Programming Manual

Hide thumbs Also See for VIVO-D102:

Advertisement

Quick Links

VIVO-D102(M)
Quick installation and programming guide
This quick guide is a summary of the complete installation manual. The manual contains safety warnings
IMPORTANT
and other explanations which must be taken into account. The installation manual can be downloaded by
NOTE
going to the "Downloads" section at the Erreka website:
http://www.erreka.com/Automatismos/descargaDocumentos.aspx
ELECTRICAL CABLING:
Element
A: Main power supply
B: Flashing light / Traffic light
C: Photocells (Tx / Rx)
D: Pushbutton/wall key
E: Operator (motor + encoder)
F: Operator release
G: Antenna
Elements of the complete installation
Nº threads x section
2
3x1.5mm
2
2
2x0.5mm
/ 3x0.5mm
2
2
2x0.5mm
/ 4x0.5mm
2
2x0.5mm
2
Duct (2x1mm
+ interior screened duct
2
2x0.5mm
)
2
2x0.5mm
k
Coaxial cable 50
(RG-58/U)
G
E114A
Maximum length
30m
20m
30m
50m
8m (maximum 25m with
2
cable 2x2.5mm
)
25m
5m
English
9

Advertisement

loading
Need help?

Need help?

Do you have a question about the VIVO-D102 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Erreka VIVO-D102

  • Page 1 This quick guide is a summary of the complete installation manual. The manual contains safety warnings IMPORTANT and other explanations which must be taken into account. The installation manual can be downloaded by NOTE going to the "Downloads" section at the Erreka website: http://www.erreka.com/Automatismos/descargaDocumentos.aspx Elements of the complete installation E114A...
  • Page 2 General connections STOP CABLE CONNECTOR: connect to the release switch D102: 230Vac/ 50Hz (in the models with encoder D102M: 125Vac/ 60Hz and release). In the models without release, make an ADO01 electrical bridge. BAT: (2x12V/1,2 Ah) BATTERY IN/OUT MOTOR SNG1 Blue (motor) ENCODER Red (motor)
  • Page 3 Turning direction change and check (C1)  This operation is only necessary if the operator opens the gate instead of closing it when making a reset (rS). Radio code programming, P1 (only with RSD receiver)  If a receiver other than RSD is used, see corresponding instructions.
  • Page 4 Complete programming chart Pre- Parameter determined Options or values option Motor turning direction Disabled Closing safety device (photocell or strip) Device not installed Device without testing Device with testing ç Total opening radio code programming Disabled Door open/close programming ç Functioning mode Automatic Step-by-step...

This manual is also suitable for:

Vivo-d102m