Motor Connection - Unitek BAMOCAR-D3 Manual

Elektrical Installation
Motor – power connection
Use only UNITEK approved, electronically commutated synchronous motors
( brushless dc motors, ec motors) with resolver or incremental encoder .
Refer Appendix A ( motor specific connection and parameter guidelines)
Connection sequence
Cable indication
Motor phase
Connector
Correct wiring is essential !
Cable cross –section minimum.
Type BAMOCAR -Dx
Cable dim. mm
Cable dim. AWG
Motor choke.
Only required upwards of a shield capacity of >5nF. approx. 25m motor cable.
Magnetic rings
Against HF failures of the sensor systems. Slide the rings onto the motor lines.
Shielded connection:
Surface connection at entry to control cabinet. Surface or as short as possible connection
at the motor end.
M1 M2 M3
U V W
xb:2 xb:3 xb:4
-125 -200
25 35
2 1
Motor cables,
3 wires + simply shielded
protective earth conductor for
600V~, 1000V=, shield capacity
150pF/m.
25