Interface - Unitek BAMOCAR-D3 Manual

Electrical Installation
Serial interface RS232
The Amplifier BMOCAR-D3 is programmed and commissioned through the PC interface
RS232 .
The software is described in the software-manual DS NDrive.
Connection between the BAMOCAR-D3 ( d-connector X10 ) and the serial interface only
through a null modem-cable.
Do not use null modem-link cable!
Cable to be plugged in only in de-energized condition.
Select the interface baud rate in NDrive as 115200.
Null modem cable
Pin assignment. Solder side.
Contact shield with the plug housing.
Cable length max. 10m
The serial interface is galvanically
coupled with the device - zero (GND) .
31