Mechanical Installation - Unitek BAMOCAR-D3 Manual

Mechanical Installation

Important instruction
Check the equipment for mechanical damage
Install only defect-free equipments
Assembly only in non-energized condition
Disconnect the positive and negative terminals of the battery,
disconnect DC supply.
Assembly only by trained personnel
The installation position is discretionary in case of equipments with
liquid cooling.
In case of very low heat dissipation, the equipment is shut down by
its thermal monitoring system.
Equipment fitment holes to be obtained from dimension drawing or drill plan
not to be traced out from the equipment itself.
Filter and choke to be mounted close to the equipment.
Connect cable screens with mounting area so as to have surface contact.
Lay power cables ( battery and motor cables ) well separated from signal cables
observe minimum cable cross –section.
Unscreened cable ends to be as short as possible.
Secure earth connection from housing to ground plane
( vehicle ground, control panel –earth)
Use vibration resistant screw joints.
11