Keypad Navigation; Entering Programming Mode - Mircom TAS-2000 Series User Manual

Introduction

Keypad Navigation

The diagram below shows how to use the keypad when in programming mode. It applies to both
Scrolling and Non-Scrolling Directory keypads.
Press to enter a
record when in edit
mode or to delete a
record when in
delete mode
In the programming
menu, press to
scroll up.
In programming mode,
press to exit
without saving (does not
apply to edit or delete
modes).
Note: If you are programming a function and do not enter information for three minutes,
the display will return to the programming menu without saving your changes. If
you are in the programming menu for 3 minutes, the display will return to the main
screen.

Entering Programming Mode

Note: Before programming the system, make sure you have filled out the Resident
Directory Worksheet on page 29.
To make changes to either scrolling or non-scrolling directories, you must first enter programming
mode.
Entering Programming mode
Enter the Password
[_ _ _ _ _ _ _ _ _ _]
2
5
4
7 8
0
0
Press to select an item in
the programming menu
9 9
1. Press
2. Enter the password.
• If you have not set a personal password,
press
(ten-digit factory default).
• If you have set a personal password, enter your 10-
digit password.
You are now in programming mode.
3
9
Press
edit or delete mode
In the programming
menu, press
scroll down.
In programming mode,
press
changes and continue
(does not apply to
delete mode).
9 9
.
9
to exit the
to
to save your