Initial Setup; Turning The Tv On For The First Time - Logik L24HEDW19 Instruction Manual

Initial Setup

Turning the TV On for the First Time

1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the ANT socket on the back of your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
2. Plug the TV into a mains socket and switch on at the
mains.
3. In standby mode, press the
control to turn the TV on. The red LED indicator will
flash for a few seconds then the TV will switch on.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
from the mains power. To completely disconnect the mains power, please remove the mains plug from the mains
socket.
Viewing TV Through an Aerial
The first time you turn the TV on, it will go straight into the First Time Installation
menu. Most of the settings are pre-set so you can just press OK. Please ensure the
aerial is plugged in.
4. Press the
5. Press the
6. Select Home Mode by pressing the OK button.
14
Logik 24' HD Ready LED TV with DVD Player L24HEDW19(B) Manual.indd 14
button on the remote
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV
buttons to highlight your LANGUAGE then press OK.
buttons to highlight your COUNTRY then press OK.
LAN
VGA
SPDIF
SCART
LAN
VGA
SPDIF
(not included)
SCART
RF coaxial cable
24/09/2019 14:51