Table of Contents
Advertisement
Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the AERIAL IN socket at the rear right bottom view of
your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
2. Connect the mains cable to the mains socket after
you have completed all the connections.
3. In standby mode, press the
control to turn the TV on. The red LED indicator will
turn blue.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The STANDBY button on the front right side panel of the TV or the
switching the TV into standby, it does not disconnect the TV from the mains power. To completely disconnect the
mains power, please remove the mains plug from the mains socket.
4. The first time you turn the TV on, it will go straight into the First Time
Installation menu. Please ensure the aerial is plugged in and then press
the OK button. (If you have already installed the TV using the Quick Start
Guide, please skip this section).
5. Your TV should be automatically sent to the correct OSD language and
Country. So simply press OK to start tuning in your TV.
If you need to change the OSD language and Country press the
buttons. Leave the TV in Home mode.
14
L32HE13A_IB.indd 14
button on the remote
HDMI 1 In
HDMI 2 In
SCART
button on the remote control is only used for
Please ensure aerial is plugged in!!
Then press OK button to start
First Time Installation
OSD Language
Country
OR
RF coaxial cable
(not included)
PC
PC-RGB In
RF In
Audio In
To the mains
socket
English
UK
Home Mode
Next
OK
16/06/2014 18:15
Advertisement
Table of Contents
