Part Name (Rbc-As21E2); Rbc-Ax31U(W)-E, Rbc-Ax31U(Ws)-E - Toshiba RBC-EXW21E2 Quick Reference

Part Name
<RBC-AX31U(W)-E, RBC-AX31U(WS)-E>
• When turning on the power supply for the first time, it will take up to 3 minutes before the [SET DATA] symbol will
flash. This flashing display will last for around 1 minute.
While this display is flashing, the model is being automatically confirmed.
After the minute has passedand the [SET DATA] display has disappeared, you can then use the remote controller.
1
2
3
ADR
4
10
<Display section>
1
Transmitting indication
Displayed while oerating the switches on the remote
controller.
2
Mode display
The selected operation mode is displayed.
[AUTO] mode is displayed on heat recovery type
only.
3
Fan mode select display
The selected fan mode is displayed.
(AUTO)
(HIGH)
(MED.)
(LOW)
4
Filter display
If "FILTER " is displayed,clean the air filter.
5
Remote temperature sensor display
Displayed when remote temperature sensor is
selected.
6
Set up temperature display
The selected set up temp. is displayed.
7
Flap position display
8
SWINGdisplay
Displayed during up / down movement of the louver.
9
Timer time display
Time of the timer is displayed. (When a fault has
occurred the check code is displayed.)
10
Timer SETIN setup display
When pushing the Timer SET button, the display of
the timer is selected in order of [OFF]
[OFF] repeat OFF timer
display.
5
6
7
8
9
→
] [ON] → No
– 8 –
1
2
3
SET
CL
4
ACL
<Operation section>
1
Operation select button
Selects the desired operation mode.
2
Fan mode select button
Selects a fan mode.
3
Timer set button
TIMER SET button is used when the timer is setup.
4
Check button
CHECK button is used for check operation. During
normal operation, do not use this button.
5
Temperature set button
Adjusts the required room temperature.
Set required set temperature by pushing
6
Start/Stop button
When this button is pushed the operation starts.
Push the button again and the operation will stop.
When the operation stops, the operation lamp and
all the displays will disappear.
7
Filter reset button
Resets (Erases) "FILTER
OPTION :
Remote controller sensor
Usually the TEMP. sensor of the indoor unit is used to
monitor the room's temperature. However it is possible
to use the remote controller as a means of measuring
the room temperature. For further details please contact
the dealer who you purchased the air conditioner from.
For details, contact the dealer from which you have
purchased the air conditioner.
NOTE :
When a mode prohibited by the central control is
selected in the local settings on an indoor unit and you
want to change another setting of the indoor unit, select
the prohibited mode on the remote controller before
configuring the setting you want to change.
5
6
ADR
7
SENSOR
or .
" display.