Specific Indoor Unit Priority Mode - Toshiba RBC-EXW21E2 Quick Reference

11. Specific Indoor Unit Priority Mode

< Procedure >
1
TEST
Push button and temp. setup
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure. Confirm that the CODE No. is [01].
• If the CODE No. is not [01], push
erase the display content, and repeat the
procedure from the beginning.
(No operation of the remote controller is accepted
for a while after
TEST
2
Each time you push
numbers in the control group change cyclically.
Select the indoor unit you want to change settings
for.
The fan of the selected unit runs. You can confirm
the indoor unit for which you want to change
settings.
3
Using temp. setup
∗∗
CODE No. [ ].
button
TEST button to
button is pushed.)
UNIT LOUVER
button, indoor unit
/ buttons, specify
4
Using timer time
∗∗∗∗
DATA [
5
SET
Push button. When the display changes from
flashing to lit, the setup is completed.
• To change settings of another indoor unit, repeat
from Procedure
• To change other settings of the selected indoor
unit, repeat from Procedure
Use button to clear the settings.
SET
To make settings after
repeat from Procedure
6
When settings have been completed, push
button to determine the settings.
When TEST button is pushed, "SETTING" flashes and
then the display content disappears and the air
conditioner enters the normal stop mode.
(While "SETTING" is flashing, no operation of the
remote controller is accepted.)
– 45 –
/ buttons, select SET
].
2
.
3
.
button was pushed,
SET
2
.
TEST