Advertisement
• Electric feed screw motor to transfer the fuel from the bunker to the burner (power up to
180 W)
• Electric internal auger motor to forward the fuel into the burning chamber (power up to
180W)
• Main blower with smooth speed control to regulate the air flow (power up to 180W)
• Additional cleaning fan (power up to 900W)
• Linear cleaning actuator with one or two control outputs (up to 180W).The second output
is an option (AUX)!
• Exhaust gases fan with smooth speed control (power up to 180W)
• Heating element to fire the pellets (power up to 900W)
• Hot water Beamer circulation pump (power up to 180W)
• Central heating installation circulation pump (power up to 180W)
• (Optional) Analogue output (0..10V) for frequency inverter to power up a powerful air fan
• Photo sensor to detect the burning fire
• Temperature sensor or thermostat to control the back burning
• Temperature sensor to control the temperature of the water in the boiler
• Temperature sensor for the hot water heater
• High temperature sensor pt100 for detecting the fire and control the temperature of the
exhaust gases.
• A potential free contact of a room thermostat for better control of the burner and
circulation pump of the heating installation according to the room temperature.
• Connector for additional control module with room thermostat function NRC-8-SV
• USB interface for connection with a computer for software uprade
User Manual / ver. 1.2
Electronic pellet burner controller - NPBC-V6T-2
Mechanisms and sensors controlled by NPBC-V6T-1
http://www.naturela-bg.com/en/
page 5 of 41
Advertisement
