Advertisement
It is important when setting the power Suspend, parameters not to allow increasing of the cycle
between two feeding of the pellets and then the pellets in the burning chamber to burn out, and
not leave enough ember to ignite the next pellets!
Itern Clean- This menu sets one additional option which the controller NPBC-V6T has to offer -
Intermediate cleaning. While the burner works normally it increase the speed of the fans, and
this goes to increase the temperature of the fire for a short time, and this will lead to completely
burning the slag and the ash. For this option row '' Output FC'' must be activate. In this case the
way of the control of the additional cleaning mechanism connected to the output FC is set from
menu '' Service setting " » "Additional cleaning".
You must have in mind that when setting "FC + pause" or "FC + AUX" is selected, the actual
duration of the intermediate cleaning is two times longer from the set one!
On every 10 min of the burner's
work, the intermediate cleaning
will be executed for 30 seconds
At intermediate cleaning
the fans will
change to 76 main and
0 exhaust fan
At intermediate cleaning
FC output will be activated
More Settings
-
Here you can set the capacity of auger motor, the calorific value of the fuel and the
speed of the main and exhaust gases fans during the extinguishing.
For the correct calculation of the current burner power and correct data and graphs for the
consumption of pellets, it is important the auger capacity and the calorific value of the fuel to be
correctly entered.
User Manual / ver. 1.2
Electronic pellet burner controller - NPBC-V6T-2
http://www.naturela-bg.com/en/
page 38 of 41
Advertisement
