Table of Contents
Advertisement
234
IN CASE OF EMERGENCY
High Intensity Discharge (HID) Headlamps —
If Equipped
The headlamps contain a type of high voltage
discharge light source. High voltage can remain
in the circuit even with the headlamp switch off.
Because of this, you should not attempt to
service a HID headlamp light source yourself. If
an HID headlamp light source fails, take your
vehicle to an authorized dealer for service.
NOTE:
On vehicles equipped with HID headlamps,
when the headlamps are turned on, there is a
blue hue to the lights. This diminishes and
becomes more white after approximately
10 seconds, as the system charges.
WARNING!
A transient high voltage occurs at the bulb
sockets of HID headlamps when the
headlamp switch is turned ON. It may cause
serious electrical shock or electrocution if not
serviced properly. See an authorized dealer
for service.
NOTE:
We advise referring to an authorized dealer.
Replacing Exterior Bulbs
Headlamps
Hi/Lo Beam Light Halogen
The bulbs can be accessed from the wheel liner
with the following procedure:
1. Turn the front wheels completely.
2. Remove the wheel liner.
3. Remove the headlamp bulb cap.
Headlamp
1 — Low Beam Bulb Cap
2 — High Beam Bulb Cap
4. Rotate the headlamp bulb socket counter-
clockwise then pull outwards.
Headlamp Bulb Socket
5. Push on the locking tab on the headlamp
bulb connector and remove the bulb and
socket.
6. Install the new headlamp bulb making sure
it's properly locked.
7. Install the headlamp bulb and socket; turn it
clockwise making sure it is properly locked.
8. Reinstall the wheel liner.
Hide quick links:
Advertisement
Table of Contents
