Parkview Rear Back Up Camera - Jeep COMPASS 2020 Owner's Manual

212 STARTING AND OPERATING

PARKVIEW REAR BACK UP CAMERA

The ParkView Rear Back Up Camera allows you
to see an on-screen image of the rear
surroundings of your vehicle whenever the gear
selector is put into REVERSE. The image will be
displayed in the touchscreen display along with
a caution note to "check entire surroundings"
across the top of the screen. After five seconds
this note will disappear. The ParkView camera is
located on the rear of the vehicle above the rear
license plate.
NOTE:
The ParkView Rear Back Up Camera has
programmable modes of operation that may be
selected through the Uconnect System. Refer to
"Uconnect Settings" in "Multimedia" for further
information.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the previous screen appears
again. When the vehicle is shifted out of
REVERSE (with camera delay turned on), the
camera image will continue to be displayed for
up to 10 seconds after shifting out of REVERSE
unless the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK or
the vehicle's ignition is placed in the OFF
position.
Zone
Red
Yellow
Green
NOTE:
With Camera Delay turned on, the camera
image can be disabled via the Image Defeat (X)
button on the touchscreen when the vehicle is
shifted out of REVERSE.
When enabled, active guidelines are overlaid on
the image to illustrate the width of the vehicle
and its projected backup path based on the
steering wheel position. A dashed center line
overlay indicates the center of the vehicle to
assist with parking or aligning to a hitch/
receiver.
Different colored zones indicate the distance to
the rear of the vehicle.
The following table shows the approximate
distances for each zone:
Distance To The Rear Of The Vehicle
0 - 1 ft (0 - 30 cm)
1 ft - 6.5 ft (30 cm - 2 m)
6.5 ft or greater (2 m or greater)