Ignition Switch; Keyless Enter-N-Go - Ignition - Jeep COMPASS 2020 Owner's Manual

16 GETTING TO KNOW YOUR VEHICLE

IGNITION SWITCH

Keyless Enter-N-Go — Ignition
This feature allows the driver to operate the
ignition with the push of a button as long as the
key fob is in the passenger compartment.
The START/STOP push button ignition has three
operating modes. The three modes are OFF,
ON/RUN, and START.
NOTE:
If the ignition state/mode does not change with
the push of a button, the key fob may have a low
or depleted battery. In this situation, a back up
method can be used to operate the ignition
switch. Put the nose side (side opposite of the
emergency key) of the key fob against the
START/STOP ignition button and push to
operate the ignition.
START/STOP Ignition Button
The push button ignition can be placed in the
following modes:
OFF
The engine is stopped.

Some electrical devices (e.g. Central locking,

alarm, etc.) are still available.
ON/RUN
Driving mode.

All the electrical devices are available.

START
Start the engine.

WARNING!
When exiting the vehicle, always remove

the key fob from the vehicle and lock your
vehicle.
Never leave children alone in a vehicle, or

with access to an unlocked vehicle.
Allowing children to be in a vehicle unat-

tended is dangerous for a number of
reasons. A child or others could be seriously
or fatally injured. Children should be
warned not to touch the parking brake,
brake pedal or the gear selector.
Do not leave the key fob in or near the

vehicle, or in a location accessible to chil-
dren, and do not leave the ignition of a
vehicle equipped with Keyless Enter-N-Go
in the ON/RUN mode. A child could operate
power windows, other controls, or move the
vehicle.
Do not leave children or animals inside

parked vehicles in hot weather. Interior
heat build-up may cause serious injury or
death.
(Continued)