Jeep COMPASS 2020 Owner's Manual page 145

Enhanced Accident Response System Reset Procedure
After the event occurs, when the system is active, a message regarding fuel cutoff is displayed. Turn the ignition switch from ignition AVV/START or
MAR/ACC/ON/RUN to ignition STOP/OFF/LOCK. Carefully check the vehicle for fuel leaks in the engine compartment and on the ground near the engine
compartment and fuel tank before resetting the system and starting the engine.
Depending on the nature of the event the left and right turn signal lights, located in the instrument panel, may both be blinking and will continue to
blink. In order to move your vehicle to the side of the road, you must follow the system reset procedure.
Customer Action
1. Turn ignition STOP/OFF/LOCK. (Turn Signal Switch Must be placed in
Neutral State).
2. Turn ignition MAR/ACC/ON/RUN.
3. Turn right turn signal switch ON.
4. Place turn signal in neutral state.
5. Turn left turn signal switch ON.
6. Place turn signal in neutral state.
7. Turn right turn signal switch ON.
Customer Will See
NOTE:
Each step MUST BE held for at least two seconds
Right turn light BLINKS.
Left turn light is OFF.
Right turn light is ON SOLID.
Left turn light BLINKS.
Right turn light is OFF.
Left turn light BLINKS.
Right turn light BLINKS.
Left turn light is ON SOLID.
Right turn light BLINKS.
Left turn light is OFF.
Right turn light is ON SOLID.
Left turn light BLINKS.
SAFETY 143
4