Adjustment - Power Mount Hardware - Permobil BodiLink HS Operation Manual

ADJUSTMENT - POWER MOUNT HARDWARE

Adjusting Power Mount Hardware.
W
= Width/Medial Adjustment
H
= Height
1
Loosen the following screws:
H
Slider height set screws (each side of the post), using the 3mm hex key.
W
Medial arm adjustment screw, using the 5mm hex key.
Note: If no medial positioning is needed, the medial arm can be removed and the
support pad mount bracket can be fastened directly to the vertical slider post.
A Pad swivel screw, using the 5mm hex key.
May need to be adjusted in combination with the above.
D
Mounting block screws (if necessary), using the 5mm hex key.
H & D
Pad mount screws (if necessary), using the 5/32" hex key.
2
Position the pad to the desired height, width location, and transverse angle.
Note: The pad and/or medial adjustment arm should not compress the seat surface.
3
Fully tighten all screws that were loosened in step 1, using the appropriate hex key.
D
BodiLink on Permobil Corpus Operation Manual
A
= Angle
D
= Depth
H & D
13
A
W
H
Removable Hardware shown
LPTS
Medial Arm Removal
Long
Screw
Short
Screw
Long
Screw