Table of Contents
Advertisement
USER MANUAL //
STRETCHER PC-610/7
Review 12/19
04
OPERATING
04.4
Tensors
To adjust the tension of the drive cables, the stretcher has
three sets of tensioners for adjunstment:
3
2
1
1. HANDLE UNLOCKING BACK LEGS
2. HANDLE UNLOCKING FRONT LEGS
3. INTERMEDIATE STOP SHAFT
To regulate the tensioners, you have a clamping flange
where you can replace the tensioning cable (if it breaks) or
regulate its tension.
To adjust the tension of the cable has two locknuts (D).
Using a wrench 11 loosen the nut 2 and adjust the tension
of the cable using the nut 1. Tighten the nuts 1 and 2 again.
If the cable breaks, proceed to cut the cap, loosen the screws
(A-B) and remove the cable pulling from the handle terminal
(C).
A
B
C
1
2
3
1
2
D
25
Advertisement
Table of Contents
