Advertisement
INSTRUCTIONS FOR ASSEMBLY
10.
Install the upper diffuser (does not contain wear
ring) and the discharge. Make sure to align the strap
locations on the discharge with the holes in the
motor bracket.
Depending on the size of pump, the slot may have a
different configuration and location on the discharge.
11.
Apply anti-seize (White Knight) to the threaded studs
on each strap. Insert strap into slot. Ensure strap is
completely seated into the slot. Slide threaded stud
into motor bracket mounting hole. Ensure the stud
extends through the hole.
12.
To ensure straps are completely seated, use a rubber
hammer to tap them down.
13.
Repeat Steps 11 and 12 for each strap.
14.
Slide washer onto the stud and thread nut. Repeat
for other straps. Torque per Table 2.0. Recommend
tightening in a crisscross pattern to maintain even
torque on all sides.
For 10" models, place Strap Blocks on motor bracket
to prevent strap twisting during installation and
tightening process.
NOTE: The stainless steel strap nuts have been
anodized to prevent galling.
Absence of
Neoprene
Packing
11
12
14
10
13
7
Advertisement
